This usually happens when:

• the iron wasn’t hot enough
• not enough pressure was applied
• the surface was too soft (like an ironing board)

For best results, iron on a hard surface like a countertop.

A firm surface works best. Ironing boards can be too soft and may prevent the adhesive from bonding properly.

Press firmly with a hot iron for 10-20 seconds, moving slowly across the entire patch so every area receives heat.

Yes. Once applied, the patch is permanent and washable.

Wash on a gentle cycle if needed. Lay flat to dry.

Simply place the parchment paper over the patch and iron again for 10-20 seconds, focusing on the edges.

Most customers place the patch inside the wide end of the tie near the tip so it remains hidden while worn.